ELECTROLUX-REX LI1070E User Manual download pdf (Page 22)

Accurate levelling prevents vibration, noise

and displacement of the machine during

operation.

Caution! Never place cardboard,

wood or similar materials under the

machine to compensate for any

unevenness in the floor. After having

levelled the appliance, tighten the lock

nuts.

Water inlet

An inlet hose is supplied and can been

found inside the machine drum. Do not use

the hose from your previous machine to

connect to the water supply.

This appliance must be connected

to a cold water supply.

1. Connect the hose with the angled con-

nection to the machine.

2. Do not place the inlet hose downwards.

Angle the hose to the left or right de-

pending on the position of your water

tap.

3. Set the hose correctly by loosening the

ring nut. After positioning the inlet hose,

be sure to tighten the ring nut again to

prevent leaks.

45°

35°

4. Connect the hose to a tap with a 3/4”

thread. Always use the hose supplied

with the appliance.

The inlet hose must not be lengthened. If it

is too short and you do not wish to move

the tap, you will have to purchase a new,

longer hose specially designed for this type

of use.

Water drainage

The end of the drain hose can be posi-

tioned in three ways.

• Hooked over the edge of a sink using

the plastic hose guide supplied with the

machine. In this case, make sure the end

cannot come unhooked when the ma-

chine is emptying. This could be done by

tying it to the tap with a piece of string or

attaching it to the wall.

• In a sink drain pipe branch. This

branch must be above the trap so that

the bend is at least 60 cm above the

ground.

• Directly into a drain pipe at a height of

not less than 60 cm and not more than

90 cm. The end of the drain hose must

always be ventilated, i.e. the inside diam-

eter of the drain pipe must be larger than

the outside diameter of the drain hose.

The drain hose must not be kinked.

22 electrolux

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 28

Comments to this Manuals

No comments