LI 1470 E... ...EN WASHING MACHINE USER MANUAL
Select the Delay Start by pressingbutton 6Before you start the programme, if you wishto delay the start, press the button 6 re-peatedly, to select the
Interrupting a programmePress the button 8 to interrupt a pro-gramme which is running, the correspond-ing green pilot light starts blinking.Press the
with a special detergent then rub in thesoap and water.Oil based paint: moisten with benzinestain remover, lay the garment on a softcloth and dab the
WASHING PROGRAMMESProgramme - Maximum and Minimum Tempera-ture - Cycle Description - Maximum Spin Speed -Maximum Fabrics Load - Type of LaundryOptions
Programme - Maximum and Minimum Tempera-ture - Cycle Description - Maximum Spin Speed -Maximum Fabrics Load - Type of LaundryOptionsDetergent Com-part
Programme - Maximum and Minimum Tempera-ture - Cycle Description - Maximum Spin Speed -Maximum Fabrics Load - Type of LaundryOptionsDetergent Com-part
Programmes Load(kg)Energy con-sumption(kWh)Water con-sumption (li-tre)Approximateprogrammeduration (mi-nutes)Remainingmoisture(%)1)Wool/Hand wash30 °C
12Flush it out under a tap, to remove anytraces of accumulated powder.To aid cleaning, the top part of the additivecompartment should be removed. Clea
4. Release the emergency emptying hose(B), place it in the container and re-move its cap cover5. When no more water comes out, un-screw the pump cover
has finished the cycle, and is empty. Whenrefitting the pump cover, ensure it is se-curely retightened so as to stop leaks andyoung children being abl
Electrolux. Thinking of you.Share more of our thinking at www.electrolux.comCONTENTSSafety information 2Safety instructions 3Product description
display and some acoustic signals soundevery 20 seconds to indicate that the ma-chine is not working:• : problem with the water supply.• : problem wit
Problem Possible cause/SolutionThere is water on the floor:Too much detergent or unsuitable detergent(creates too much foam) has been used.• Reduce th
Problem Possible cause/SolutionSpinning starts late or the machine does notspin:The electronic unbalance detection device hascut in because the laundr
2. Remove the power supply cable andthe draining hose from the hose holderson the rear of the appliance.3. Unscrew the three bolts with the sup-plied
Water inletAn inlet hose is supplied and can beenfound inside the machine drum. Do not usethe hose from your previous machine toconnect to the water s
tying it to the tap with a piece of string orattaching it to the wall.• In a sink drain pipe branch. Thisbranch must be above the trap so thatthe bend
BUILDING INOverviewThis appliance has been designed to bebuilt into the kitchen furniture. The recessshould have the dimensions shown in Fig.1.Fig. 16
Fig. 5BAd) Counter-magnetThe appliance is prearranged for a magnet-ic closure of the door.To enable a correct operation of this device,it is necessary
www.electrolux.com/shop132924673-A-262014
• Obey the maximum load volume of 7 kg (refer to the “Pro-gramme chart” chapter).• If the supply cord is damaged, it must be replaced by themanufactur
• The first time you use the appliance,make sure that there is no leakage.UseWarning! Risk of injury, electricalshock, fire, burns or damage to theapp
5Drain pump6Front adjustable feet7Water drain hose8Mains cable9Water inlet valve10Back adjustable feetDetergent dispenser drawer Compartment for deter
CONTROL PANELBelow is a picture of the control panel. It shows the programme selector dial as well asthe buttons, pilot light and the display. These a
Start PauseThis button allows you to start or to inter-rupt the selected programme.Door locked pilot lightThe pilot light 9 illuminates when the pro-g
•Super Quick •Refresh •Super Refresh When selecting a programme on the dis-play appears an icon indicating the degreeof soiling automatically proposed
Pull out the dispenser drawer until it stops.Measure out the amount of detergent re-quired, pour it into the main wash compart-ment or in the appropr
Comments to this Manuals